VBUS.UVWTHRESH

Description

This parameter is the DC bus undervoltage warning threshold. When the measured DC bus voltage falls below the threshold, an undervoltage fault is thrown for each axis.

Examples

Usage

The drive configures the default value for this parameter based on power electronics ratings.

When the measured DC bus voltage VBUS.VALUE is less than VBUS.UVWTHRESH, the drive reports Warning 2007: Bus under voltage (See W2007 ). When VBUS.VALUE is greater than VBUS.UVWTHRESH, the warning is removed.

Code

The following example demonstrates the DC bus undervoltage warning check. When the bus voltage is greater than the warning threshold, the undervoltage warning is not reported.

--> VBUS.UVWTHRESH 100
--> VBUS.UVWTHRESH
100 [Vdc]
--> VBUS.VALUE
162.297 [Vdc]
--> DRV.WARNINGS

No warnings active

When VBUS.VALUE is less than VBUS.UVWTHRESH, the warning is reported on each axis.

--> VBUS.VALUE
96.895 [Vdc]
--> DRV.WARNINGS
1-2007: Warning: Bus under voltage.
2-2007: Warning: Bus under voltage.

Context

For more information on DC bus voltage protection, refer to Power View and Regeneration.

Versions

Action	Version	Notes
Implemented	02-00-00-000

General Information

Type	Read/Write
Units	VDC
Range	0 to 900 VDC
Default Value	Dependent on drive model
Data Type	Integer
See also	VBUS.UVMODE, VBUS.UVTHRESH, VBUS.VALUE
Stored in Non-Volatile Memory	Yes

Variants Supported

All variants are supported.

Fieldbus Information

EtherCAT CoE and CANopen

Command	Index	SubIndex	Data Type	Units	Float Scale	Access	PDO Mappable
VBUS.UVWTHRESH	300ah	03h	Unsigned16	-	-	Read/Write	No

EtherNet/IP

Name	ID	Hex	Data Type	Access	Units
VBUS.UVWTHRESH	2511	9CF	Unsigned16	Read/Write	-

PROFINET

Parameter	PNU	Data Type	Access	Units
VBUS.UVWTHRESH	2511	Unsigned16	Read/Write	-